Garza's Alumawood Pergola Arbor Lattice

Picture - 01 Enlarge Image

Garza's Job Details:

• ORDERED: June 2005
• SIZE: 16' projection x 17'-10" length
• LOCATION: Wiggins, MS
• DESIGN LOAD: 10 Pound Live Load and 90 Mile Per Hour Wind Factor
  Note: ICBO ER2621-P Report used for engineering.

• ATTACHMENT: Attached to Wall and Concrete Slab
• COLOR: White
• QUANTITY OF POSTS: 2
• APPROXIMATE COST: $2,900

Note: This Pergola Kit has a Reinforced Beam with a Steel C-Beam Insert to span 17'-10" with only two posts. The posts we supplied are 12' tall (instead of 8') and Column Trim has also been used to finish off the tops of the Round Columns.

Garza's Job Specifications:

• ROUND COLUMNS: Customer Supplied Round Columns locally.
  (We supplied the structural posts that go inside the Round Columns.)
• STRUCTURAL POSTS: .041” Steel Thick x 3” x 3” Wide x 12’-0” Tall.
  Post Insert is covered by Round Column, the Post insert is not visible once Column is installed.
• COLUMN TRIM: 2”Wide x 6 ½” Tall with End Cap.
  Installed on top of Column to aesthetically tie the beam and Column Top Cap together.
• ALUMAWOOD™ RAFTERS: .032” Thick x 2” Wide x 6½” Tall
• END CAP STYLE (Rafter Tails and Beam): Corbel End Caps
• ALUMAWOOD™ LATTICE TUBES: .019” Thick x 1½” Wide x 1½” Tall
• LATTICE CAP STYLE: Beveled
• ALUMAWOOD™ BOX BEAM: .042” Thick x 3” Wide x 8” Tall Box Beam
• STRUCTURAL "C" BEAM INSERT: Steel "C" Type 12 gauge Red Oxide Primed 2.88” Wide x 7.88” Tall.
  "C" Beam Insert is covered by Alumawood™ Box Beam, the "C" Beam insert is not visible once cover is installed.
• MISC. SUPPLIES: Brackets, Hardware and Touch Up Paint.
• ALUMA-SHIELD℠ PAINT: Silicon polyester paint finish in White
• DESIGN LOAD: 10 Pounds Per Square Foot Live Load
• WIND FACTOR: 90 mph Max
• ENGINEERING REPORT: ICBO ER2621-P